+8615280858852
1. Circular Locus Pilling Tester structure 2. Circular Locus Pilling Tester working principle Under the specified speed and pressure, nylon brush and fabric are used as abrasives, and the sample runs in a circular trajectory and rubs against the abrasives to make the sample rub and fuzz. Finally, the samples were evaluated by visual description of pilling performance under standard light source. 3...
Testing method Take out the square on the left side of Lab Pilling Assessment Box, place the sample flat in the recess, and place a chart on the right side of the recess for comparison. Observe the sample and the chart with a line of sight perpendicular to the surface of the sample to judge the level of the condition of the sample surface. Steps 1. Put ICI Assessment Box on a flat table. 2. Turn o...
AVENO can customize the machine, such as ICI Pilling and Snagging Tester, and the cabinet can be customized, as shown in the figure: ICI Pilling and Snagging Tester is used to determine the surface fuzzes and pilling properties of both woven and knitted materials. It complies in full with the requirements of EN ISO 12945-1 and BS 5811, etc .. The optional pilling drum are: A) Square pilling test b...
Random Tumble Pilling Tester is used to determine the pilling and fuzzing characteristics of textile fabrics under the condition of free rolling friction in the cylinder. During testing, sample continuous, random friction with cork lining in rotation of stainless steel vane. Test time is controlled by timers and audio alarms. Compressed air also can be injected into the test chamber to enhance ove...
1) ICI Pilling and Snagging Tester is packed in a whole box. The wooden box is not allowed to lie on its side during transportation, and it is strictly forbidden to turn the wooden box upside down. 2) During the transportation and unpacking of the ICI Pilling and Snagging Test Chamber, try to prevent shocks or severe vibrations. When unpacking, first remove the box cover, and then remove the four ...
1) Before the ICI Mace Snag Tester experiment, first place a sufficiently large fabric sample to be tested in a temperature of 20 ± 2 ° C and a relative humidity of 60% ± 2% for 24 hours. 2) From the fabric to be tested, parallel warp at a distance of 1/10 of the width, and cut out two pieces of samples with a size of 200mm × 330mm in the weft direction without damage or defects. 3) At the middle ...