+8615280858852
+8615280858852
There is residual formaldehyde in the textile. Under the action of temperature and humidity, formaldehyde will be released to different extents. During the storage and use of textiles, formaldehyde can enter the human body through breathing and skin contact, causing various diseases and even causing diseases. Textile Formaldehyde Content Tester can detect textile formaldehyde residues. The followi...
AG38 Fabric Stretch & Recovery Tester Operating specification Prepare test pieces 1. sampling Samples are taken - one roll of fabric is used as a sampling unit, and one roll is randomly selected from the available raw materials, or samples agreed by the buyer and the seller are taken. Specimens - Two sets of three 65 mm x 560 mm specimens were cut from the end of a roll of cloth 1 m, and the l...
Please add the lube to the belt pulley axletree and rotating member to make it working well. Please clean the Fabric Pilling Tester face everyday after your test, and you should spray the rust preventing oil regularly. Please check the tightness of the Random Pilling Tester’s belt regularly, and adjust or change the new belt of same standard depending on the circumstance. AVENO Machine R...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch 100CM² Sample Cutter. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure...
Make sure that the safety catch is locked. Loosen the blade retaining screws to allow the blade retaining plates to be removed, then either turn or replace the blades. Replace the blade retaining plates and tighten the screws. Repeat this procedure for each blade. Note that blades may be rotated until all cutting corners have been used. AVENO Machine Recommend AG26 100CM2 Sample Cutter Contact Us ...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch it. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure to the handle and...
online service
+8615280858852
sales@avenotester.com
+8615280858852
