+8615280858852
+8615280858852
The type of test is divided into dry test and wetting test. 1. Dry Friction a) Flatly put sample on the friction apparatus placing sandpaper, make the length of the specimen is in line with the direction of the moving track of the Rubbing Fastness Tester, and fix sample on the pressuring plate, the folder should be flat. b) Standard friction small white cloth fix on the friction head, clamp it tig...
Please add the lube to the belt pulley axletree and rotating member to make it working well. Please clean the Fabric Pilling Tester face everyday after your test, and you should spray the rust preventing oil regularly. Please check the tightness of the Random Pilling Tester’s belt regularly, and adjust or change the new belt of same standard depending on the circumstance. AVENO Machine R...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch 100CM² Sample Cutter. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure...
1. Sample Preparing Every sample should be put in the environment with temperature 20~250℃ and humidity 20~70% for more than 4 hours. 2. Testing Procedure 2.1. Keep the sample shape and static without moving. 2.2. Remove the test part from the entire toy in order the Toy Safety Sharp Edge Tester can touch it, but must keep the original rigidity. 2.3. The beginning and end of the PTFE tape can be c...
1. Always keep the Taber Abrasion Tester clean and tidy by wiping the Taber Abrasion Resistance Tester with cotton cloth. 2. The metallic surface shall be applied with anti-rust oil. 3. Fill lubricating oil for the moving parts at regular intervals. AVENO Machine Recommend: AF46 Taber Abrasion Tester Contact Us Now! Sales Dept Tel: +86 15280858852 Email: sales@avenotester.com Skyp...
1. Friction head for plastic products, have been finished friction before going out factory, should no gap with stainless steel plate, friction head should be touched directly with sandpaper when uses. It is easy friction head to wear rather than flat. Larger gap with steel plate results in uneve pressure from the samples and impacting on testing results. 2. The speed of friction head has been adj...
online service
+8615280858852
sales@avenotester.com
+8615280858852
