+8615280858852
The type of test is divided into dry test and wetting test. 1. Dry Friction a) Flatly put sample on the friction apparatus placing sandpaper, make the length of the specimen is in line with the direction of the moving track of the Rubbing Fastness Tester, and fix sample on the pressuring plate, the folder should be flat. b) Standard friction small white cloth fix on the friction head, clamp it tig...
AG38 Fabric Stretch & Recovery Tester Operating specification Prepare test pieces 1. sampling Samples are taken - one roll of fabric is used as a sampling unit, and one roll is randomly selected from the available raw materials, or samples agreed by the buyer and the seller are taken. Specimens - Two sets of three 65 mm x 560 mm specimens were cut from the end of a roll of cloth 1 m, and the l...
Please add the lube to the belt pulley axletree and rotating member to make it working well. Please clean the Fabric Pilling Tester face everyday after your test, and you should spray the rust preventing oil regularly. Please check the tightness of the Random Pilling Tester’s belt regularly, and adjust or change the new belt of same standard depending on the circumstance. AVENO Machine R...
1. Wash fastness tester instrument leaking ▲Check if the drain connector or drain valve is secure ▲Whether it is the connection of the heating pipe joint, the water level gauge, the rotating shaft, it is tightened or the gasket needs to be replaced. ▲Excessive water levels can also cause water leaks. 2.After installation, power on the work interface and click “Rotate”. The mot...
Leather Lastometer Ball Burst Tester is used to test crack resistance Index of all kinds of vamp, shoe upper material and other leather surfaces. Leather Lastometer Ball Burst Tester’ test principle: fixed specimen circumference then the steel ball as a speed of 12mm/min rises upward from the inner side of the leather, when a crack occurs on the sample surface, record the height of the rise and th...
1. Friction head for plastic products, have been finished friction before going out factory, should no gap with stainless steel plate, friction head should be touched directly with sandpaper when uses. It is easy friction head to wear rather than flat. Larger gap with steel plate results in uneve pressure from the samples and impacting on testing results. 2. The speed of friction head has been adj...