+8615280858852
+8615280858852
Make sure that the safety catch is locked. Loosen the blade retaining screws to allow the blade retaining plates to be removed, then either turn or replace the blades. Replace the blade retaining plates and tighten the screws. Repeat this procedure for each blade. Note that blades may be rotated until all cutting corners have been used. AVENO Machine Recommend AG26 100CM2 Sample Cutter Contact Us ...
1. Sample Preparing Every sample should be put in the environment with temperature 20~250℃ and humidity 20~70% for more than 4 hours. 2. Testing Procedure 2.1. Keep the sample shape and static without moving. 2.2. Remove the test part from the entire toy in order the Toy Safety Sharp Edge Tester can touch it, but must keep the original rigidity. 2.3. The beginning and end of the PTFE tape can be c...
1.Installed abrasive paper (before installation, please put gloves, the fingers were not galled by sand) Get abrasive paper that length is 473 +-1mm and width is 400 mm at least. But those two items do not exceed roller, the average thickness is about 1.0 0.2 mm. Get three bars double-face tape that is equal to roller, the thickness is 0.2mm at most, the width is 50mm, add them on roller well-di...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch 100CM² Sample Cutter. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure...
1. Before using Low Temperature ROSS Flexing Tester, first check if there is a reliable grounding device. 2. The laboratory voltage must be stable, it is best to install a voltage regulator in the laboratory, when the voltage is unstable, do not use the test equipment, so as to avoid the phenomenon of short circuit burning circuit board due to voltage instability. 3. When replacing the test piece,...
Please add the lube to the belt pulley axletree and rotating member to make it working well. Please clean the Fabric Pilling Tester face everyday after your test, and you should spray the rust preventing oil regularly. Please check the tightness of the Random Pilling Tester’s belt regularly, and adjust or change the new belt of same standard depending on the circumstance. AVENO Machine R...
AG38 Fabric Stretch & Recovery Tester Operating specification Prepare test pieces 1. sampling Samples are taken - one roll of fabric is used as a sampling unit, and one roll is randomly selected from the available raw materials, or samples agreed by the buyer and the seller are taken. Specimens - Two sets of three 65 mm x 560 mm specimens were cut from the end of a roll of cloth 1 m, and the l...
The type of test is divided into dry test and wetting test. 1. Dry Friction a) Flatly put sample on the friction apparatus placing sandpaper, make the length of the specimen is in line with the direction of the moving track of the Rubbing Fastness Tester, and fix sample on the pressuring plate, the folder should be flat. b) Standard friction small white cloth fix on the friction head, clamp it tig...
Hi friends, December is not only AVENO discount month, but also is AVENO Thanksgiving Feedback Month. Within this time, we will offer best discount base on best quality, as a thanksgiving feedback to our customer, thanks the always support of all of you to AVENO. Thank you. If you have any inquiry, please contact us, our team is looking forward to serve you better. Sales Dept Tel: +86 1528085...
online service
+8615280858852
sales@avenotester.com
+8615280858852
