+8615280858852
What is Electronic Twist Tester? Electronic Twist Tester is special equipment used to measure the yarn twist, degree of inhomogeneity of yarns in certain lengths of cotton, wool, linen, and silk, and the twisting and shrinkage of strands, as a basis for assessing product quality and improving the production process. The test method of Electronic Twist Tester? Average untwisting slip elongation Ave...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch it. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure to the handle and...
Make sure that the safety catch is locked. Loosen the blade retaining screws to allow the blade retaining plates to be removed, then either turn or replace the blades. Replace the blade retaining plates and tighten the screws. Repeat this procedure for each blade. Note that blades may be rotated until all cutting corners have been used. AVENO Machine Recommend AG26 100CM2 Sample Cutter Contact Us ...
1.Installed abrasive paper (before installation, please put gloves, the fingers were not galled by sand) Get abrasive paper that length is 473 +-1mm and width is 400 mm at least. But those two items do not exceed roller, the average thickness is about 1.0 0.2 mm. Get three bars double-face tape that is equal to roller, the thickness is 0.2mm at most, the width is 50mm, add them on roller well-di...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch 100CM² Sample Cutter. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure...
1. Before using Low Temperature ROSS Flexing Tester, first check if there is a reliable grounding device. 2. The laboratory voltage must be stable, it is best to install a voltage regulator in the laboratory, when the voltage is unstable, do not use the test equipment, so as to avoid the phenomenon of short circuit burning circuit board due to voltage instability. 3. When replacing the test piece,...
Please add the lube to the belt pulley axletree and rotating member to make it working well. Please clean the Fabric Pilling Tester face everyday after your test, and you should spray the rust preventing oil regularly. Please check the tightness of the Random Pilling Tester’s belt regularly, and adjust or change the new belt of same standard depending on the circumstance. AVENO Machine R...
1.AATCC Crockmeter Purpose and Scope This test method is designed to de-termine the amount of color transferred from the surface of colored textile materials to other surfaces by rubbing. Suitable for textile products such as yarn, yarn dyeing, printing and dyeing. Not recommended for carpets and printed textiles that are too small. 2.Principle Under certain conditions, the test sample is rubbed a...
1.Before test, clean the ICI Pilling Box with a vacuum cleaner or brush, make sure do not leave any fibers. 2.Placed equipped sample in the ICI Pilling Box. 3.Close the lid of the ICI Pilling tester for Fabric pilling box and fix it. 4.Set the number of revolutions of the ICI Pilling and Snagging Tester. 5.After test, take our the sample and remove the suture. AVENO Machine Recommend: ...
ICI Pilling and Snagging Tester is used to determine the surface fuzzes and pilling properties of both woven and knitted materials. It complies in full with the requirements of EN ISO 12945-1 and BS 5811, etc.. Below is the attention items: Maintenance tips: Regularly check the control panel keys and the screws on each part normal. Regularly clean the cork liner with suitable cleaning solvent, suc...